Hi all,
Hope everyone is doing okay!
It has been a while, been a busy few years but I have been popping on here every so often.
My zed is finally at the bodyshop to have the widebody conversion done. In 2018 I sourced a set of rear arches and back bumper from what I believe was a pre-facelift 2.8 Z3.
The shop are having issues getting the bumper to line up with the rear arch.
The arch aligns correctly at the 'front' of the bumper but there is a gap between the rear of the arch and the bumper - see below:
Just wondering if there are any other parts I need to source (bumper mounting bracket or the mounting points on the chassis) and if the bumper and arches look correct (from a 2.8 widebody)
I am going to do some of my own research but thought I would post this in case anyone has ran into a similar problem.
Hope everyone is doing okay!
It has been a while, been a busy few years but I have been popping on here every so often.
My zed is finally at the bodyshop to have the widebody conversion done. In 2018 I sourced a set of rear arches and back bumper from what I believe was a pre-facelift 2.8 Z3.
The shop are having issues getting the bumper to line up with the rear arch.
The arch aligns correctly at the 'front' of the bumper but there is a gap between the rear of the arch and the bumper - see below:
Just wondering if there are any other parts I need to source (bumper mounting bracket or the mounting points on the chassis) and if the bumper and arches look correct (from a 2.8 widebody)
I am going to do some of my own research but thought I would post this in case anyone has ran into a similar problem.
Attachments
-
109.1 KB Views: 15
-
86.2 KB Views: 15
-
85.9 KB Views: 15